Taiss 3590S-2-203L Rotary Potentiomete 20K ohm Potentiomete 10-Turn Multi Turn Wire Wound Precision Potentiometer+Counting Dial Rotary Knob

Works fine lasts a long time.

I needed to repair a Hewlett Packard powert supply but it had to be accomplished on a budget. This item was a very close match but I had to cut the shaft a little shorter and file a flat spot on it for the knob's set screw to contact. Otherwise it works great.

I bought these so I could wire these in line with my HO alternator to add resistance so it would trick the vehicle/alternator into thinking I need more voltage hence giving me a extra volt which it worked perfectly and my amplifiers love it !!!

I ordered two units (four potentiometers) and received two packages:The first had a pair of 10k ten-turn panel mount potentiometers with knobs (but NOT the counting knobs which were the only real selling point). At least these pots were decently smoothe and solid feeling (but no counting knobs).The second package contained five PCB mount rotary encoders which on top of everything else were defective (upon disassembly I discovered why all positions were open circuit to one another at all points in its rotation -- no metalized layer on the rotor!).Neither item was what I ordered and the second was worse than useless since curiosity caused me to disassemble it to figure out WTF was wrong with it even though a rotary encoder could in no way be a drop in replacement for a potentiometer.

Based on some of the other reviews for this (And other muliturn pots available) I immediately tested the resistance when I received this one. Read 0.3 Ohm at the low end and 10.00 KOhm at the high end. Works great.

It's a 10-turn potentiometer. It works exactly as expected and is reasonably precise. Note that it can be a little tricky to install the dial to a panel, and I'd recommend wiring the potentiometer BEFORE installing it into the panel.

Es exactamente lo que solicite.

I figured there would be a wiring diagram that shows what the three pins are. Which is which?

easy to install

Very good

Works great in my home made power supply. The only reason I didn't give it 5 stars is because the dial mechanism feels cheap and sometimes catches when the counter changes. Other than that, highly recommend it.